B737 Lighting
Boeing 737 lighting comprises the exterior lights that light the ground ahead and make the airplane visible, the flight deck panel, flood and dome lights with their master lights test, the passenger cabin signs, and an emergency lighting system that switches itself on after a loss of normal power if its flight deck switch is at ARMED.
The Boeing 737's lights fall into four groups. Exterior lights let the crew see the runway and taxiways and let other aircraft, controllers and ground staff see the airplane. Flight deck lights make the panels readable by day and by night, and one switch tests the indicator lights. Passenger cabin signs, switched from the flight deck, tell passengers when to stay in their seats. The emergency lighting system shows everyone the way out when the airplane's normal electrical power has failed.
Lighting is a favorite of the type rating ground exam because every light has a fixed place, a switch with its own logic and a moment in the normal procedures. This article follows the 737 Next Generation (NG) flight crew operations manual (FCOM); the 737 MAX differences recorded by the FAA are listed at the end, and an operator's own manual takes precedence where installations differ. For the rules on which lights must be shown and when, see aircraft exterior lighting; lighting inside the airplane in general is covered in flight deck, cabin and emergency lighting.

Exterior lights
Maintenance documents, and the FAA's differences tables for the 737, file lights under ATA chapter 33. The 737 NG carries the following exterior lights:
| Light | Where on the 737 NG | Notes |
|---|---|---|
| Retractable landing lights | Lower fuselage | Shine forward parallel to the waterline; may be extended at any speed |
| Fixed landing lights (two) | Wing leading edge | Fixed, shining forward and down |
| Runway turnoff lights | Each wing root | Light the area in front of the main gear |
| Taxi light | Nose landing gear | With an AUTO switch position, goes out when the nose gear retracts |
| Position lights | Red left and green right at the forward wingtip, at the base of the winglet; white at the trailing edge of both wingtips | Steady; switched with the strobes on the POSITION switch |
| Strobe lights (three) | Left and right forward winglet, and the tail cone | High-intensity white flashes |
| Anti-collision lights (two) | Top and bottom of the fuselage | Red strobes on the ANTI COLLISION switch |
| Logo lights | Top of each horizontal stabilizer | Light both sides of the vertical stabilizer |
| Wing illumination lights | Fuselage | Light the wing leading edge |
Landing, taxi and runway turnoff lights
The 737 NG has two kinds of landing light. The retractable landing lights are housed in the lower fuselage and, once extended, shine forward parallel to the airplane's waterline. They may be extended at any speed, so there is no extension speed to respect in the climb or descent. The two fixed landing lights are built into the wing leading edge and point forward and down; they have no moving parts to extend.
The FCOM's normal procedures for the most common variants name the fixed landing light switches. The first officer's preflight leaves the landing light switches at RETRACT and OFF. The fixed landing lights come on with the takeoff clearance and go off during the climb, once the airplane is at or above 10,000 ft MSL. The Approach procedure switches them back on while the airplane is still at or above 10,000 ft MSL, so that they burn throughout the descent below it. Other lights are used as needed.
The runway turnoff lights, in the wing roots, light the ground in front of the main gear. As their name says, they light the way when turning off the runway. The taxi light is on the nose landing gear. Where the TAXI switch has an AUTO position, the light stays on while the gear is extended and goes out by itself when the nose gear retracts after takeoff. Both switches, like the landing lights, are left OFF in the first officer's preflight.
Some airplanes have LED landing, taxi and runway turnoff lights, for which the FCOM gives a rule of its own: when the landing lights and the taxi light are both at ON or AUTO, the landing light function overrides the taxi light function. The airplane's own FCOM pages show whether it has them.
Exam tip: retractable landing lights in the lower fuselage, extendable at any speed; fixed landing lights in the wing leading edge; runway turnoff lights in the wing roots, lighting the area ahead of the main gear; taxi light on the nose gear, out automatically when the gear retracts if its switch is at AUTO.
Position, strobe, anti-collision and logo lights
The position lights, also called navigation lights, follow the international color code: red on the left and green on the right, both at the forward end of the wingtip at the base of the winglet, and white lights at the trailing edge of both wingtips.
One POSITION switch controls the position lights and the strobes together. At STEADY, the red, green and white position lights are lit and nothing flashes. At STROBE & STEADY, the position lights stay on and the three high-intensity white strobe lights flash as well: one on the left forward winglet, one on the right forward winglet and one in the tail cone. The FCOM's Takeoff procedure turns the strobes on as the airplane enters the departure runway, at the same moment as the transponder goes to TA/RA.
The two anti-collision lights are red strobes, one on top of the fuselage and one underneath, with their own ANTI COLLISION switch. The Before Start procedure sets it ON, so a flashing red light warns the ground crew that the engines are about to be started and that they must keep clear.
SERA requires an aircraft that carries anti-collision lights to display them in daylight too, both in flight and on the movement area. It also allows the pilot to turn off, or dim, a flashing light that hampers the crew's work or risks dazzling someone outside, while the steady position lights remain lit. In the United States, 14 CFR 91.209 gives the pilot in command a similar freedom: the anti-collision lights need not be on when operating conditions make it safer to switch them off. Strobe flashes reflected back into the flight deck from cloud or haze are a common reason.
The logo lights sit on top of each horizontal stabilizer and shine on both sides of the vertical stabilizer, where the operator's logo is painted. Electrically they count among the cabin and utility loads: setting the CAB/UTIL switch to OFF removes their power along with the galleys, the recirculation fans and other cabin equipment (see B737 electrical system). The wing illumination lights are mounted on the fuselage and light the wing leading edges, so that the crew can inspect the wing in the dark, for instance for ice.
Flight deck lighting
Panel lighting has separate brightness controls. On the captain's side, the MAIN PANEL control covers three things: the captain's own panel and instruments, the center instrument panel, and the autopilot flight director system (AFDS) panel, both its displays and its edge lighting. The BACKGROUND control on the left forward panel sets the incandescent background lighting of the captain's, first officer's and center panels.
General lighting comes from the dome lights, whose DOME control has three positions, DIM, OFF and BRIGHT, and from the instrument flood lights. The standby compass has its own light switch, with OFF, BRT and DIM.
The lights a crew needs most after an electrical failure are protected. When normal electrical power is lost, standby power reaches the dome lights, the instrument flood lights, the standby compass light and a selection of system information and warning lights automatically. The aft dome light also contains a separate bulb, powered by the emergency lighting system, that lights the flight deck for an evacuation.

The master lights test
The master LIGHTS TEST and DIM switch checks the flight deck indicator lights in one action and, as its name says, also serves for dimming them. Selecting TEST recalls the master caution system as well. A light that is still on after the switch is released is not part of the test: it marks a fault stored in the master caution system, which the test leaves in place.
The check is part of the captain's preflight. While the switch is at TEST, the captain's scan flow confirms that all the other lights are on or flashing, every light on the system annunciator panels included. The fire warning lights are left out of this test, and so is any light that fails to come on in it; each is checked by means of an individual test switch or push-to-test feature. Several systems have such a dedicated test. In the first officer's preflight, the autopilot disengage light TEST switch held at 1 should give steady amber A/P, A/T and FMC lights; held at 2, A/P and A/T show steady red while FMC remains steady amber. Recall, simple faults and the twelve system annunciators are covered in B737 warning systems.
Passenger cabin signs
The cabin signs are switched from the flight deck. At AUTO, the FASTEN BELTS switch lights the FASTEN SEAT BELTS and RETURN TO SEAT signs as long as the flaps or the landing gear are extended, and puts them out only when the flaps and the gear are both retracted. Since the gear is down on the ground, on a normal flight they stay on through taxi and takeoff, go out once the gear and the flaps are up in the climb, and come back on as soon as flaps or gear are extended for the approach.
On airplanes fitted with a NO ELECTRONIC DEVICES switch, its AUTO position uses the same logic: the signs come on with the flaps or gear extended and go out when both are retracted. Each time the NO SMOKING or FASTEN BELT signs come on or go off, a single low-tone chime sounds through the passenger address speakers, so that passengers notice the change.
Emergency exit lights
For large airplanes, emergency lighting is required by the certification codes, in CS 25.812 and in its FAA counterpart, 14 CFR 25.812. On the 737 it can be controlled from two places.
On the flight deck, the EMER EXIT LIGHTS switch has a guard that holds it at ARMED. In that position the whole emergency lighting system comes on by itself when DC bus No. 1 loses power or AC power is switched off. Moved to OFF, the switch stops the system from working after a power failure or shutdown, and an amber NOT ARMED light stays lit for as long as the switch is anywhere but ARMED. At the end of the day, the Secure procedure turns it OFF along with the window heat and the air conditioning packs.
In the cabin, the aft attendant panel has a guarded passenger cabin emergency lights switch. Its ON position turns on every emergency light and overrides the flight deck control, so the cabin crew can light the escape routes whatever the position of the EMER EXIT LIGHTS switch.
Self-illuminating exit locator signs are installed at the forward end, the middle and the aft end of the passenger cabin. The photoluminescent floor path marking needs no power in an emergency, but it has to be charged beforehand, for which the cabin ceiling and sidewall lights must be at full intensity, with nothing covering or blocking the strips.
Warning: with the EMER EXIT LIGHTS switch at OFF, a power failure leaves the cabin without automatic emergency lighting. The amber NOT ARMED light is the cue that the switch has been moved from its guarded ARMED position.
Lights in the normal procedures
The 737 NG FCOM spreads the lighting actions over the normal procedures:
| Procedure | Lighting action |
|---|---|
| First officer's preflight | Landing light switches RETRACT and OFF; runway turnoff and taxi light switches OFF |
| Captain's preflight | Master LIGHTS TEST and DIM switch to TEST; lights checked by scan flow |
| Before start | ANTI COLLISION switch ON |
| Takeoff, entering the departure runway | Strobes ON; other lights as needed |
| Takeoff, cleared for takeoff | Fixed landing lights ON (most common variants) |
| Climb, at or above 10,000 ft MSL | Fixed landing lights OFF (most common variants) |
| Approach, at or above 10,000 ft MSL | Fixed landing lights ON (most common variants) |
| After landing | Exterior lights as needed |
| Secure | EMER EXIT LIGHTS switch OFF |
737 MAX differences
The FAA Flight Standardization Board (FSB) report for the 737, Revision 17, lists the lighting changes from the 737-800 to the 737-8. Outside, the 737-8 has dual tail anti-collision and position lights where the 737-800 has a single one, a configuration difference trained and checked at Level A. On the flight deck, the MAX display system comes with revised lighting controls: display brightness, the display select switch panels, master dim and test, all trained and checked at Level B. The same report lists flashing landing lights among the differences from the BBJ2 to the BBJ MAX 8.
Everything above is taken from the NG FCOM. A MAX crew should confirm switch names and logic, the display lighting in particular, in the MAX FCOM. The training levels themselves are explained in B737 NG and MAX differences.
Frequently asked questions
Where are the landing lights on a Boeing 737?
The 737 NG has two kinds. The retractable landing lights are in the lower fuselage and, once extended, shine forward parallel to the airplane's waterline; they may be extended at any speed. Two fixed landing lights are built into the wing leading edge and shine forward and down. The runway turnoff lights sit in the wing roots, aimed at the ground just forward of the main gear, and the taxi light is on the nose gear.
What do STEADY and STROBE & STEADY mean on the 737 POSITION switch?
At STEADY only the position lights are on: red at the left wingtip, green at the right and white at the trailing edge of both wingtips. At STROBE & STEADY the position lights stay on and the three high-intensity white strobes flash as well, one on each forward winglet and one in the tail cone. The FCOM's takeoff procedure turns the strobes on when the airplane enters the departure runway.
When are the landing lights switched on and off on the 737?
In the 737 NG FCOM procedures for the most common variants, the fixed landing lights go on when the airplane is cleared for takeoff and are switched off in the climb once it is at or above 10,000 ft MSL. In the arrival they go on again at or above 10,000 ft MSL, before the descent below that level. In the first officer's preflight the landing light switches are set to RETRACT and OFF.
What does the 737 master lights test check?
At TEST the switch also recalls the master caution system. In the captain's preflight, a scan flow then confirms that all the other lights are on or flashing, every system annunciator panel light included. A light that stays on once the switch is released shows a fault stored in the master caution system. The fire warning lights are outside this test; they, and any light that stays dark, have their own test switches or push-to-test features.
When do the 737 emergency lights come on automatically?
The EMER EXIT LIGHTS switch must be at ARMED, the position in which its guard holds it. Every emergency light then comes on by itself when DC bus No. 1 loses power or AC power is switched off. With the switch at OFF the lights stay dark after a power failure, and an amber NOT ARMED light warns of it. The cabin crew have a guarded switch of their own on the aft attendant panel that lights them all and overrides the flight deck switch.
When do the seat belt signs come on in AUTO on the 737?
At AUTO, the FASTEN BELTS switch lights the FASTEN SEAT BELTS and RETURN TO SEAT signs as long as the flaps or the landing gear are extended, and puts them out once both are retracted. On airplanes with a NO ELECTRONIC DEVICES switch, its AUTO position follows the same logic. Each time the NO SMOKING or FASTEN BELT signs come on or go off, a single low chime sounds in the cabin.
Test yourself on B737 Lighting
The v1prep banks cover this topic in the B737 type-rating bank, with a worked explanation for every answer. EASA ATPL, PPL, IR and CPL, the FAA written tests and type ratings for the A320, A330, A350, 737, 767, 777, A220, 787, ATR 72 and E-Jet.
Start practicing →Sources and further reading
- FAA Flight Standardization Board Report, Boeing 737, Revision 17 (16 November 2020)
- EASA Easy Access Rules for Large Aeroplanes (CS-25), CS 25.1383 to 25.1403 Lights and CS 25.812 Emergency lighting
- 14 CFR 25.812, Emergency lighting
- 14 CFR 91.209, Aircraft lights
- EASA Easy Access Rules for Standardised European Rules of the Air (SERA)
Library articles are written for study and exam preparation. They do not replace your aircraft's approved documentation, your operator's procedures or the regulations themselves.